|
Product Materials
Molded bacterial-resistant, high density polyethylene with fulllength, steel hinge pin. Concealed gas shock assists opening and closing; eliminates pinch points. Graphics in English and Spanish permanently molded in. Integrated dual paper liner dispenser and molded-in purse/diaper bag hooks. Safety strap with 100% unbreakable buckle.
STRENGTH NOTE: Unit complies with ASTM F2285 Standard that requires commercial diaper changing stations be able to hold a minimum of 100 lbs.
Installation
Verify all rough-in dimensions prior to installation. Secure to wall through mounting holes located on 16" or 24" centers. Mounting hardware for typical conditions is included.
WARNING: Be sure to use reinforced backing behind wall where mounting screws or anchoring devices are installed to ensure adequate support for the baby changing station. All anchoring devices must be appropriate for specifi c wall construction. Severe personal injury and/or property damage may result from improper mounting.
Guide Specification
Surface-mounted baby changing station shall be grey and white speckled (961), solid light grey (9611) or ivory colored (9612) molded bacterial-resistant, high density polyethylene. Hinge shall have full-length steel hinge pin and concealed gas shock. Unit shall include dual integrated paper liner dispensers, molded-in graphics, integral bag hook, and safety strap with unbreakable buckle. Unit shall be operable with less than 5 lbs. of force and complies with ASTM F2285 Standard.
Overall dimensions: 34-1/16"W x 25"H x 31-5/16"D.
ADA Compliant
Consult local and national accessibility codes for proper installation guidelines.
Conformity and compliance to local and national codes is the responsibility of the installer.
Washroom Accessories Warranty:
Bradley Corporation warrants to commercial and institutional purchasers only each new Bradley washroom accessory unit purchased from us to be free from defects in materials and workmanship under normal use and service upon the following terms and conditions: This warranty is limited to replacing or repairing, at our option, transportation charges prepaid by the purchaser, any Bradley washroom accessory unit or part thereof which our inspection shall show to have been defective within the limitations of this warranty.
The period during which Bradley accessory units are warranted is as follows, measured from the date of our invoices:
Complete unit, excepting mirrors - one (1) year.
Stainless Steel Mirror Frames - fifteen (15) years against corrosion.
Plate Glass Mirrors - fifteen (15) years against silver spoilage.
Hand/Hair Dryers - ten (10) years (see DRYER WARRANTY).
Tempered Glass Mirrors - five (5) years against silver spoilage.
Laminate Glass - five (5) years against silver spoilage.
Polished #8 Architectural Grade Finish on 304 Series Stainless Steel - one (1) year against corrosion.
Bright Annealed Finish on 430 Series Stainless Steel - one (1) year against corrosion.
This warranty does not cover installation labor charges and does not apply to any units which have been damaged by accident, abuse, improper installation, improper maintenance, or altered in any way.
The replacement or repair of defective Bradley washroom accessory units as stated in this warranty shall constitute the sole remedy of the purchaser and the sole liability of Bradley Corporation under this warranty.
BRADLEY CORPORATION SHALL NOT UNDER ANY CIRCUMSTANCES BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR INDIRECT DAMAGES CAUSED BY DEFECTS IN BRADLEY WASHROOM ACCESSORY UNITS OR ANY DELAY IN THE REPAIR OR REPLACEMENT THEREOF.
This warranty extends only to commercial and institutional purchasers and does not extend to any others, including consumer customers of commercial and institutional purchasers.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE.
Product Maintenance Instructions |
